Smoothing Treatment:
Start with a hair analysis to understand the history of the hair, so that you can choose the correct solution for the hair type.If the hair is damaged or porous, you may need to follow the steps for pre-treatment.
1. On clean dry hair, without clarifying (make sure their last wash was with shampoo and conditioner), apply the solution close to, but not touching the scalp.
2. Ensuring the hair is saturated well, wrap the hair in a plastic cap and leave for 15 minutes.
3. After the processing time, rise the hair 100%, and until the water runs clear, and towel dry.
4. Spray W Protection heat protector spray, and blast dry the hair with a blow dryer and your fingers until the hair is 100% dry. (Do not use any tools at this stage)
5. With sections of around 1 inch, start the straightening process – ensuring that you are using a straightener that goes up to 250 degrees and has titanium plates.
6. Using a lower heat of up to 210 degrees for Blonde and Grey hair, and a higher heat for hair level 6 and lower of 230 – 250 degrees, begin straightening the hair.
7. During the passes of the straightener, go over each section using a clamp brush to stretch the hair out, and smooth the straightener over each inch section between 8 – 15 times (give or take) until the hair is shiny, soft and silky. Use Moringa Oil in between passes, to seal the cuticle and protect the hair fibre.
8. No need to wash the hair at the end!
Reviews
There are no reviews yet.